Shelly 1
Reddit take
Not enough linked mention summaries yet; the source excerpts below are the evidence.
Pros
- OP could put a dumb switch in, and put something like a Shelly 1, i4, or a Zooz ZEN51, etc at the light fixture to capture the switch state and achieve the same.
- Taster raus, Shelly 1 dazwischen, irgendwo *gestikuliert* 230V für das Teil finden, Taster wieder drüber, fertig 🙈
- After looking into smart lighting and refusing to install smart switches or remote, the only way I found to get what you described is with a shelly 1.
- I use the Shelly 1 in my house in several locations where two switches control the same lights. One smart switch responds to either switch input and controls both light output.
- I use the Shelly 1 mounted behind the switch. The switch is then connected to the Shelly and the Shelly output goes to the light. It pulls in the time of day over wifi and automatically computes sunset sunrise time. No hub needed and the...
Cons
- Shelly 1 or 1PM (relay at your light).
- Well apparently the Shelly 1 that I was trying to use fresh from a new box was defective.
- I wanted to use a shelly 1 I had laying around to accomplish this, but I can't get it to power on for a bench test by just connecting the L/N terminals with an extension cord an outlet.
- I searched online and see that it can be DIYed with a Shelly 1, but I was hoping someone sells a packaged solution.
Sentiment
6 positive (60%) · 2 mixed (20%) · 2 negative (20%)
Trust + time weighted score: +35% · raw score 40%
What redditors said (10 of 10)
Shelly 1 or 1PM (relay at your light).
OP could put a dumb switch in, and put something like a Shelly 1, i4, or a Zooz ZEN51, etc at the light fixture to capture the switch state and achieve the same.
Taster raus, Shelly 1 dazwischen, irgendwo *gestikuliert* 230V für das Teil finden, Taster wieder drüber, fertig 🙈
Well apparently the Shelly 1 that I was trying to use fresh from a new box was defective.
I wanted to use a shelly 1 I had laying around to accomplish this, but I can't get it to power on for a bench test by just connecting the L/N terminals with an extension cord an outlet.
After looking into smart lighting and refusing to install smart switches or remote, the only way I found to get what you described is with a shelly 1.
I searched online and see that it can be DIYed with a Shelly 1, but I was hoping someone sells a packaged solution.
I use the Shelly 1 in my house in several locations where two switches control the same lights. One smart switch responds to either switch input and controls both light output.
I use the Shelly 1 mounted behind the switch. The switch is then connected to the Shelly and the Shelly output goes to the light. It pulls in the time of day over wifi and automatically computes sunset sunrise time. No hub needed and the wifi connection is stable.
When I originally set up my Shelly 1 to notify me of my garage door status, I followed "The Hook Up" guide... and used a reed switch as the way of indicating door position. It worked well for a few years
Compare
Related
- Shelly relay · parent · 25 mentions
- DF54 · related · 707 mentions
- Apple TV · related · 482 mentions
- Baratza Encore ESP · related · 390 mentions
- DF64 · related · 337 mentions
- Amazon Alexa · related · 242 mentions
- Apple TV 4K · related · 197 mentions